Hello
I am trying to do some DFT+U calculations. In surface relaxation process, the process starts and after 6 or 7 itarations it goes off and gives this message
=====================================================================================
= BAD TERMINATION OF ONE OF YOUR APPLICATION PROCESSES
= EXIT CODE: 15
= CLEANING UP REMAINING PROCESSES
= YOU CAN IGNORE THE BELOW CLEANUP MESSAGES
=====================================================================================
APPLICATION TERMINATED WITH THE EXIT STRING: Terminated (signal 15)
I never seen this before. Can somebody please tell me what the fault is.
Many thanks
exit code 15 in DFT+U ???
Moderators: Global Moderator, Moderator
-
ccccc
- Jr. Member
- Posts: 69
- Joined: Wed Feb 24, 2010 1:56 pm
- License Nr.: 4-1116 5-3053
exit code 15 in DFT+U ???
Last edited by ccccc on Mon Jun 24, 2013 12:08 pm, edited 1 time in total.
-
support_vasp
- Global Moderator
- Posts: 1817
- Joined: Mon Nov 18, 2019 11:00 am
Re: exit code 15 in DFT+U ???
Hi,
We're sorry that we didn’t answer your question. This does not live up to the quality of support that we aim to provide. The team has since expanded. If we can still help with your problem, please ask again in a new post, linking to this one, and we will answer as quickly as possible.
Best wishes,
VASP